Steve,
Here is what myexisting setup looks like. I have not started the car up yet. I am using a Holley carb bracket. It has a tab on it near the hole where it goes through the carb attachement, that on a Holley, keeps it from rotating. On the Edelbrock carb I have, I had to bend it up to get it to fit. However, there is a lot of tension/pressure from the TV cable and as you can see, the bracket has rotated from the pressure.

This shows the hookup at the carb better.

And this one is a 'top view' showing how the offset is not quite correct.

I can give you dimensions and such to fab something up, but is this something you want to do? Or can you think of another way to attack this? I am also a little concerned about the T.V. cable, it barely reaches. If you look closely at the top view, you can see the abrupt angle it is making as it passes under the distributor.

Thanks, I appreciate you thoughts.